We send all of our Mags to ELECTRIMOTION for Cam Sync upgrade and Phasing. 44 Amp, Male/HEI Pro Cap, Band Clamp Counterclockwise Rotation Black Ready to ship today!
This is the "brain" of the Power Grid System - designed for use with the 7720 ignition controller, but compatible with many of MSD's other popular ignition boxes. Requires a Windows-based laptop...
Plugs into CAN-BUS Bridge For use with Power Grid Controller 4-Connector CAN-Bus Hub required PART #: MSD 7761
Required when adding more modules to your Power Grid. Now in black! PART #77403
The Coil of the Pro Mag 44 is designed to handle the 44 amps being pumped into it from the generator and still produce plenty of high voltage. The coil...
Pro Power HVC II Coil #8261 For Use With 7 & 8-Series Ignition Control
The Electronic Points Box with Rev Limiter is responsible for controlling the Pro-Mag 44’s energy. Black Part# 81473
MSD Pro Cap Replacement 5 inch (Black) Part #74083
MSD Pro Cap Replacement 5 inch (Red) Part #7408
The Ford-style cap has a provision for the coil wire to be routed in separately PART #84083
Replacement Rotor for the Pro Cap. Fits 7455 PART# 7423
Pro- Cap Replacememnt Wire Retainer (BLACK)
Pro Cap Base Replacement, Black PART# 74563
Outputs can trigger a relay to activate a shifter, nitrous, etc. For use with Power Grid PART #7760
Manual Launch Control Module Make Last Minute Changes Change Shift Light and RPM Launch For use with Power Grid Controller Part# 7751
Digital RPM Window Switch This Switch accepts an input rpm signal from a coil negative terminal (for stock ignitions), a tach output from an ignition control, an ECU tach output...
Shielded Non-Magnetic Pickup. Shielded Wires and ground strap provide clean signal PART #8154
Inductive Spark Plug Wire Sync Kit For Use with 7-Series Programmable Ignition Controls Part# 7555
DIY CAM-SYNC PICKUP KIT Part# 2346
Non-Magnetic Pick-up For MSD Flying Magnet Crank Trigger Kits Thread: 3/4"-16 UNF Length: 2.25" 70-90 ohm Part# 8276